GDI Fuel System Depressurization Valve Stuck
2012-2015 BMW 320i 2.0L I4 Turbo N20
Description
The fuel rail depressurization valve used during service or fuel system shutdown is stuck, causing either a fuel pressure leak-down or inability to relieve pressure.
Symptoms
- Extended cranking after sitting (valve stuck open)
- Service hazard if valve stuck closed
- Fuel pressure drops overnight
- Hard hot restart
- Fuel rail holds pressure excessively long during service
Common Causes
- Valve internal seal wear
- Valve solenoid failure
- Debris holding valve open
- Corrosion on valve seat
- Wiring fault preventing valve operation
Diagnostic Steps
- Monitor fuel rail pressure decay after shutdown
- Test valve solenoid operation
- Measure pressure hold time vs specification
- Inspect valve for debris or corrosion
- Command valve during service procedure
Repair Notes
Replace depressurization valve. If pressure leak-down is the issue, also check fuel injector sealing. Always relieve fuel pressure safely before GDI service.
Related Codes
Other Powertrain Codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0010Intake Camshaft Position Actuator Circuit/Open Bank 1
- P0011Intake Camshaft Position Timing Over-Advanced Bank 1
- P0012Intake Camshaft Position Timing Over-Retarded Bank 1
- P0013Exhaust Camshaft Position Actuator Circuit/Open Bank 1
- P0014Exhaust Camshaft Position Timing Over-Advanced Bank 1
- P0015Exhaust Camshaft Position Timing Over-Retarded Bank 1
P3659 on Other Vehicles
Common Questions
What does code P3659 mean on a 2012-2015 BMW 320i?
P3659 stands for "GDI Fuel System Depressurization Valve Stuck". The fuel rail depressurization valve used during service or fuel system shutdown is stuck, causing either a fuel pressure leak-down or inability to relieve pressure.
What are the symptoms of P3659 on a BMW 320i?
Common symptoms of P3659 include: Extended cranking after sitting (valve stuck open), Service hazard if valve stuck closed, Fuel pressure drops overnight, Hard hot restart, Fuel rail holds pressure excessively long during service.
What causes P3659 on a 2012-2015 BMW 320i?
Common causes of P3659 include: Valve internal seal wear, Valve solenoid failure, Debris holding valve open, Corrosion on valve seat, Wiring fault preventing valve operation.