ShopBaseFree forever shop management software for auto repair shops
Try ShopBase Free β†’
C0080

Steering Position Sensor Calibration Not Performed

2004-2008 Chrysler Crossfire 3.2L V6

Low SeverityChassisGeneric (SAE)

Description

The steering angle sensor has not been calibrated or the calibration was lost.

Symptoms

  • Stability control light on
  • ESC inoperative
  • Lane departure warning inactive
  • Steering center point unknown to module

Common Causes

  • Battery disconnect cleared calibration
  • Alignment performed without recalibration
  • Module replacement
  • Steering component service

Diagnostic Steps

  1. Perform steering angle sensor calibration with scan tool
  2. Drive vehicle in a circle to auto-learn center point
  3. Verify calibration completed successfully
  4. Check for other stability codes that prevent calibration

Repair Notes

Perform steering angle sensor calibration. Most vehicles require a scan tool procedure followed by a driving routine.

Related Codes

C0076Steering Angle Sensor CircuitC0077Steering Position Sensor Range/Performance

Other Chassis Codes

C0080 on Other Vehicles

Common Questions

What does code C0080 mean on a 2004-2008 Chrysler Crossfire?

C0080 stands for "Steering Position Sensor Calibration Not Performed". The steering angle sensor has not been calibrated or the calibration was lost.

What are the symptoms of C0080 on a Chrysler Crossfire?

Common symptoms of C0080 include: Stability control light on, ESC inoperative, Lane departure warning inactive, Steering center point unknown to module.

What causes C0080 on a 2004-2008 Chrysler Crossfire?

Common causes of C0080 include: Battery disconnect cleared calibration, Alignment performed without recalibration, Module replacement, Steering component service.

View Labor Times | View Torque Specs | View Fluid Specs