Camshaft Profile Actuator A Stuck Bank 1
2000-2002 Rolls-Royce Corniche 6.75L V8
Description
The camshaft profile switching actuator for Bank 1, intake side, is mechanically stuck in one position. Multi-profile camshafts switch between low and high RPM cam lobes.
Symptoms
- Check Engine Light
- Loss of high-RPM power
- Rough idle if stuck on high cam
- VTEC/VANOS-like system not engaging
- Engine sounds different at high RPM
Common Causes
- Oil sludge blocking actuator passages
- Actuator solenoid failure
- Low oil pressure
- Worn actuator pins or springs
- Incorrect oil viscosity
Diagnostic Steps
- Check engine oil level and condition
- Monitor camshaft profile PID on scan tool
- Command profile switch and verify response
- Test oil pressure at actuator feed
- Inspect actuator screen for debris
Repair Notes
Flush engine oil system. Replace cam profile actuator solenoid. If pins are worn, camshaft replacement may be needed.
Related Codes
Other Powertrain Codes
- P0001Fuel Volume Regulator Control Circuit/Open
- P0002Fuel Volume Regulator Control Circuit Range/Performance
- P0003Fuel Volume Regulator Control Circuit Low
- P0004Fuel Volume Regulator Control Circuit High
- P0010Intake Camshaft Position Actuator Circuit/Open Bank 1
- P0011Intake Camshaft Position Timing Over-Advanced Bank 1
- P0012Intake Camshaft Position Timing Over-Retarded Bank 1
- P0013Exhaust Camshaft Position Actuator Circuit/Open Bank 1
- P0014Exhaust Camshaft Position Timing Over-Advanced Bank 1
- P0015Exhaust Camshaft Position Timing Over-Retarded Bank 1
P3010 on Other Vehicles
Rolls-Royce Cullinan
2019-2024 6.75L V12 Twin Turbo
Rolls-Royce Dawn
2016-2024 6.6L V12 Twin Turbo
Rolls-Royce Ghost
2010-2024 6.6L V12 Twin Turbo
Rolls-Royce Phantom VII
2003-2017 6.75L V12
Rolls-Royce Phantom VIII
2018-2024 6.75L V12 Twin Turbo
Rolls-Royce Silver Seraph
1998-2002 5.4L V12
Rolls-Royce Wraith
2014-2024 6.6L V12 Twin Turbo
Common Questions
What does code P3010 mean on a 2000-2002 Rolls-Royce Corniche?
P3010 stands for "Camshaft Profile Actuator A Stuck Bank 1". The camshaft profile switching actuator for Bank 1, intake side, is mechanically stuck in one position. Multi-profile camshafts switch between low and high RPM cam lobes.
What are the symptoms of P3010 on a Rolls-Royce Corniche?
Common symptoms of P3010 include: Check Engine Light, Loss of high-RPM power, Rough idle if stuck on high cam, VTEC/VANOS-like system not engaging, Engine sounds different at high RPM.
What causes P3010 on a 2000-2002 Rolls-Royce Corniche?
Common causes of P3010 include: Oil sludge blocking actuator passages, Actuator solenoid failure, Low oil pressure, Worn actuator pins or springs, Incorrect oil viscosity.